TPP: Plantronics Headset Blackwire C725 - SwyxIt! 2015 (kb4704)
Le informazioni contenute nel presente articolo riguardano i seguenti prodotti:
- SwyxWare 2015
- SwyxIt! 2015
- Plantronics Headsets
Within the Swyx Technology Programme (TPP) the Plantronics Headset Blackwire C725 was successfully tested with a SwyxIt! 2015 and reaches therefore the certification level certified.
The Plantronics Blackwire C725 is a corded USB headset with an integrated inline control. For operation with the SwyxIt!, it is necessary to install the Plantronics Hub software, which can be downloaded from http://www.plantronics.com/de/product/plantronics-hub-desktop/. The installed software allows to configure some general Plantronics settings. There is no device specific configuration for the C725.
Plantronics Hub Software: V3.4
BlackWire C725 Firmware: USB v.136
HP Compac DC5100 MT, Win7, SP1
HP Compac 6000 Pro MT, Win8
HP Pro 3520, Win8.1
Windows Default Speaker: Internal Speaker
Windows Default Microphone: Plantronics C725
SwyxIt! Headset: Plantronics C725
SwyxIt! Signaling: Internal Speaker
SwyxIt!: No additional ringing on internal speaker
Plantronics Hub: C725 as primary device
Ringtones on primary device only
1.2 Executed tests
The tests were classified into
- Installation and configuration
- Accepting and terminating calls
- Volume control
- Unplug and replug of C725
The tests completed successfully; the different test PCs or operating systems did not influence the test results.
- If the SwyxIt! is configured to play the ringtones on the C725 instead of the internal PC speaker, the volume of the ringtones can only be adjusted by the C725 itself, using the appropriate configuration dialog or during an incoming call.
If the SwyxIt! is muted by the SwyxIt! control during an incoming call or in idle state, the mute LED on the inline control of the C725 remains off.
If the mute button is pressed on the inline conrol of the C725 during an incoming call or in idle state, the mute control of the SwyxIt! remains unchanged (unmuted).
In both cases, if the call is accepted or during call establishment, the itself is muted.
- By pressing the call button of the inline control for a longer period during an existing call, it is possible to put a call on hold or to retrieve a held call.
During in incoming call, no Plantronics ringtone is played by the C725.
Depending on the configured ring location in the plantronics Hub Software and the ringing device in the SwyxIt!, the SwyxIt! ring tone and the Plantronics ringtone might interfere.
2 Installation and configuration
SwyxIt! 2015 must be installed. Exit SwyxIt!!
Install Plantronics Hub Software
Plug in the C725 to a free USB port.
Start the SwyxIt!
Control and configure the Windows Audio Settings and the SwyxIt! Audio Modes if necessary.