How to use SwyxConnect 172x with SwyxWare 2013 (R2) (kb4492)
Le informazioni contenute nel presente articolo riguardano i seguenti prodotti:
- SwyxWare 2013 R2
- SwyxWare 2013
- SwyxConnect 1724
- SwyxConnect 1723
- SwyxConnect 1722
[ Informazioni ]
The following configuration settings are required to successfully use SwyxConnect 172x with SwyxWare 2013 oder 2013 R2:
If SwyxConnect 172x is used as 3rd party SIP gateway, or 3rd party SIP devices, ISDN phones or analog devices are registered via SIP at SwyxServer, you need to configure the following registry key:
Background information: SwyxConnect 172x creates for each SIP reregistration a new SIP Call-ID. SwyxWare 2013 follows more exact the RFC 3261 definitions to differentiate between new registrations and reregistrations. With the above mentioned key SwyxWare 2013 acts more tolerant regarding this issue.
If the above mentioned devices are registered via SwyxConnect 172x at a SwyxServer 2013 and you want to use the transfer functionality, then you need to add the following registry key:
Background information: SwyxWare 2013 uses the message headers defined in RFC 3515 for SIP REFER requests. SwyxConnect 172x does not fully comply to this standard. Via the registry key you can switch to an alternative method.
Hint: Both registry keys will change the SwyxServer behavior globally! Please use these keys only, if SwyxConnect 172x and the above mentioned scenarios are in use.