HOWTO

SwyxConnect configuration update for SwyxWare 2011 and 2011 R2 (kb4256)

Le informazioni contenute nel presente articolo riguardano i seguenti prodotti:

  • SwyxWare 2011 R2
  • SwyxWare 2011
  • SwyxConnect 1724
  • SwyxConnect 1723
  • SwyxConnect 1722

[ Riepilogo | Informazioni ]


Riepilogo

This article describes the SwyxConnect device configuration for the usage with SwyxWare 2011 or 2011 R2.


Informazioni

1. Use one of the following quickstarts for the initial SwyxConnect configuration:

SwyxConnect 1722

SwyxConnect 1723

SwyxConnect 1724

 
Open the SwyxWare Administration once the initial SwyxConnect configuration is completed.

2. Every SwyxWare user who uses an ISDN or Analogue phone which is connected to SwyxConnect must disable the voice encryption feature.
 

img-672
Cliccare per ingrandire...
Furthermore if one of the devices is a fax, the user setting "Prohibit T.38 reinvite by sender" has to be enabled.
 
img-672
Cliccare per ingrandire...

3. Run the Swyx LANconfig Tool and open the configuration dialog for the corresponding SwyxConnect device. Select "VoIP Call Manager -> Lines" in the menu. Click on the "SIP lines" button on the right side. A new window appears. Double-click on the list entry named "WIZ_SWYXWARE_GW". A further window appears. Select the "Codecs" tab. Ensure that only the "G.711 (u-Law) - 64 kbit/s" codec is selected.
img-672
Cliccare per ingrandire...


Once you have changed the settings close the "SIP-Line" windows.

4. Select "VoIP Call Manager -> Lines" in the menu. Click on the "SIP-PBX-lines" button on the right side. A new window appears. Double-click on the list entry named "WIZ_SWYXWARE-PBX". A further window appears. Select the "Codecs" tab. Ensure that only the "G.711 (u-Law) - 64 kbit/s" codec is selected.
img-672
Cliccare per ingrandire...


Once you have changed the settings close the "SIP-PBX-Line" windows.

5. Select "VoIP Call Manager -> Codecs" in the menu. Ensure that only the "G.711 (u-Law) - 64 kbit/s" codec is selected.
img-672
Cliccare per ingrandire...


Once you have changed the settings close configuration dialog and Swyx LANconfig Tool.
The configuration update has been completed now.

 

Notice regarding T.38 (FaxOverIP protocoll):
Of course the transmissing of fax with help of the T.38 FaxOverIP protocoll is still possible and supported. The previous configuration steps do not turn off T.38 support.
 


Commento

L'articolo è stato utile? Lasci un commento all'articolo



Come possiamo contattarLa se dal Suo commento dovessero nascere altri quesiti?

Indirizzo e-mail Adresse (facoltativo)


Nota

Il campo destinato ai commenti non è ammesso per richieste all'assistenza. Per quesiti inerenti l'assistenza rivolgersi esclusivamente al proprio rivenditore di fiducia o al distributore competente.