SwyxWare v4.30 Hotfix 3 (kb2764)

Le informazioni contenute nel presente articolo riguardano i seguenti prodotti:

  • SwyxWare CD v4.30
  • SwyxWare v4.30

[ Riepilogo | Informazioni ]


Swyx releases the SwyxWare v4.30 Hotfix 3.

Please note the common hints on hotfixes in the following Knowledgebase article:


This hotfix 1 includes also the hotfixes

  • SwyxWare v4.30 Hotfix 1 (not yet made publicly available)
  • SwyxWare v4.30 Hotfix 2 (not yet made publicly available)

and resolves the following problems:

  • Firmware-Update does not work anymore.
    (Swyx00007299 - Hotfix 1)
  • The caller list is not timely ordered.
    (Swyx00006906 - Hotfix 2)
  • In a special situation called device continues to ring after ConnectTo times out.
    (Swyx00007307 - Hotfix 2)
  • SwyxServer uses non-ascii characters in header when sending voicemails.
    (Swyx00007306 - Hotfix 2)
  • "Matching Lines Only" not working when using internal S0 and MSNs.
    (Swyx00007348 - Hotfix 2)
  • Protection failure within Linemanager. PhoneManager and SwyxIt! are affected. For this reason you should also install (Swyx00007367 - Hotfix 3)
  • Lots of access violations in ConferenceManager caused by a race condition.
    (Hotfix 3)
  • Increased max. number blocks/frames in jitterbuffer of ConferenceManager(cause SwyxWare uses 20ms frames from v4.30 on, instead of 30ms frames)
    (Hotfix 3)
  • The voice could not be heard with the very first intercom call on the destination.
    (Hotfix 3)

Further informations and a detailed installation instruction can be found in the included README.TXT file.


L'articolo è stato utile? Lasci un commento all'articolo

Come possiamo contattarLa se dal Suo commento dovessero nascere altri quesiti?

Indirizzo e-mail Adresse (facoltativo)


Il campo destinato ai commenti non è ammesso per richieste all'assistenza. Per quesiti inerenti l'assistenza rivolgersi esclusivamente al proprio rivenditore di fiducia o al distributore competente.