HOWTO

Installation of the Plantronics USB headset on Microsoft Windows 98 SE (kb2204)

Le informazioni contenute nel presente articolo riguardano i seguenti prodotti:

  • SwyxIt! Headset H320 (monaural)
  • Microsoft Windows 98

[ Riepilogo | Informazioni ]


Riepilogo

This document describes the installation of the Plantronics USB headset on Microsoft Windows 98 (Second Edition). Please read this document carefully before you attempt to install the headset. The steps must be performed in the correct order, or the headset – although the installation seems to be successful – may not work.

Informazioni

Please start up your computer as usual, without the headset being connected at this time. During the installation, the setup program will need to copy files from the SwyxWare CD and (possibly) from the Microsoft Windows CD. In some cases changing the CDs (which is necessary) during the setup procedure may cause problems; therefore we recommend that you copy the drivers for the headset from the SwyxWare CD to your hard disk first. Please copy the content of the folder \USB\Plantronics into a new folder on your hard disk, for example C:\Plantronics

When the headset is connected to the USB port, Windows 98 will subsequently detect and install four new devices. Only one of them needs the driver from the SwyxWare CD, the others will use Microsofts own drivers. Please select Search for the best driver for your device in all four cases. Windows will need to copy new files from the Windows CD one or two times, so please have this CD at hand.

  1. The first device will be detected as USB Composite Device. The hardware assistant will ask you for possible locations to search for the driver. Please UNCHECK all the checkboxes here. The assistant will now chose the driver supplied by Microsoft, please use this one to install the device.
  2. The next device will be detected as Plantronics headset. Please activate the checkbox Specify a location and browse to the folder C:\PlantronicsAfter the installation of the driver, the device will be named Plantronics USB Bulk Driver.
  3. The next device is called USB HID. Please use the same procedure as in step 1. Important: Make sure that the checkbox for specify a location is CLEARED, it will possibly still be active due to step two.
  4. The last device is detected as USB Audio Device. Please use the same procedure as in step 1.

Even if the operating system does not explicitly ask you to reboot, please do so anyway. After the reboot, the Plantronics USB headset will be available as a new audio device. Right now it will be selected in the multimedia control panel as preferred audio device. To play back system sounds, music etc. with your normal speakers again, you may want to open Control PanelMultimedia and switch the preferred audio device back to your normal sound card.

Further installation instructions for USB Handsets and Headsets:


Commento

L'articolo è stato utile? Lasci un commento all'articolo



Come possiamo contattarLa se dal Suo commento dovessero nascere altri quesiti?

Indirizzo e-mail Adresse (facoltativo)


Nota

Il campo destinato ai commenti non è ammesso per richieste all'assistenza. Per quesiti inerenti l'assistenza rivolgersi esclusivamente al proprio rivenditore di fiducia o al distributore competente.